A4 Sedan V6-3.2L (BKH) (2007)
/Page-1539004.png)
-
Slide combustion chamber seal as far possible onto (T10133/5 ) using (T10133/6).
-
Turn (T10133/6) around and slide combustion chamber seal into groove.
‹› When pushing the combustion chamber seal onto the fuel injector, the seal spreads open. Therefore after pushing it on, it must be tightened again
in 2 steps, as follows.
-
Press the (T10133/7) with a slight turning motion (approximately 180°) onto the fuel injector until it stops.
-
Pull the (T10133/7) off again, turning it in the opposite direction.