A4 Sedan V6-3.2L (BKH) (2007)
/Page-1972002.png)
If specified values are not obtained:
-
Adjust the selector lever cable. Refer to => [ Selector Lever Cable Adjusting ] See: Shift Linkage/Adjustments.
-
Check the ignition key removal lock.
2. Check Ignition Key Withdrawal Lock
-
Switch the ignition key to driving position ("ignition on ").
-
Press the brake pedal and hold.
‹› It must be possible to shift selector lever out of the "P" position without "hitching" while the locking button on selector lever handle is pressed.
-
Switch the ignition off.
‹› It should not be possible to remove the ignition key when the selector lever is in any other position than "P".
-
Place the selector lever in the "P" position.
‹› It must be possible to move the ignition key into the removal position without "sticking".
-
Remove the ignition key.
‹› It must be possible to remove the ignition key only in the " P" position.
‹› Selector lever cannot be shifted out of the "P" position with the locking button pressed and the brake pressed.
3. Check Locking Button on Selector Lever Handle
Check the locking button for ease of movement:
‹› It must be possible to press the locking button without great force.
‹› After releasing, the locking button must come all the way back out by itself
If specified values are not obtained:
-
Check whether the selector lever handle is installed correctly.
-
Check whether the selector rod or the selector lever is bent.
Function test:
‹› Ignition switched on
Locking button on selector lever handle must be pressed for the following shifts. If it is not pressed, the selector lever cannot be shifted into the
specified position.
‹› "P" to "R" and also press the brake pedal
‹› "D" to "S"
‹› "N" to "R"; in a stand still, also press the brake pedal after a long wait
‹› "R" to "P"
If specified values are not obtained:
-
Check whether the selector lever handle is installed correctly.
-
Adjust the selector lever cable. Refer to => [ Selector Lever Cable Adjusting ] See: Shift Linkage/Adjustments.