Audi Workshop Service and Repair Manuals

Removing and installing oil seal for selector shaft l  Gearbox installed Special tools and workshop equipment required

t  Extractor tool -T20143/1-

t  Shock absorber set -T10001-

t  Puller -T40160- t  Sealing grease -G 052 128 A1-

Removing –  Engage 1st gear. –  Remove rear noise insulation (loosen fasteners -2- and -3-).

–  Remove nut -1-.   Note -Item 2- can be disregarded.

Caution Risk of damage to selector shaft in gearbox. t  Do not prise off or knock off the gearbox selector lever -1- with a lever or hammer. t  Always use puller -T40160- when removing the gearbox selector lever. –  Apply puller -T40160- and pull off gearbox selector lever.

–  Prise out oil seal with extractor tool -T20143/1-. l  Check selector shaft for damage.

Installing –  Lightly oil outer circumference of oil seal. –  Pack space between sealing lip and dust lip half-full with sealing grease -G 052 128 A1-. –  Drive in oil seal with -T10001/1-. l  Installation depth: 2 mm below surface of housing

–  Install gearbox selector lever as follows: l  Gearbox selector lever -2- can only be fitted onto selector shaft -1- in one position (gap in splines -arrow-). –  Secure gearbox selector lever. Tightening torque → Item –  Install noise insulation → Rep. gr.66.