Servicing the Selector Mechanism for 6-Speed Manual Gearbox 0B4
| Exploded view - selector mechanism |
| 1 - | Circlip |
| q | Take out before removing ball |
| 2 - | Spacer sleeve |
| 3 - | Spring |
| 4 - | Ball guide |
| q | Do not grease |
| 5 - | Ball |
| q | Do not grease |
| 6 - | Damper |
| q | For gear lever bearing → Item |
| q | Do not grease |
| 7 - | Bolt |
| q | 23 Nm |
| 8 - | Clamping plate |
| q | Do not grease |
| 9 - | Gear lever |
| q | Bend points towards rear |
| q | Grease gear lever stops and guide for reverse gear detent; for grease refer to → Electronic parts catalogue |
| q | Grease contact surfaces for joint → Item; for grease refer to → Electronic parts catalogue |
| 10 - | Spacer tube |
| q | Grease outside circumference; for grease refer to → Electronic parts catalogue |
| 11 - | Gear lever bearing |
| q | Removing and installing → Chapter |
| q | Do not grease |
| 12 - | Joint |
| q | Between selector rod and gear lever |
| q | Grease contact surfaces for gear lever; for grease refer to → Electronic parts catalogue |
| 13 - | Bolt |
| q | For joint → Item |
| 14 - | Bolt |
| q | 23 Nm |
| 15 - | Nut |
| q | 10 Nm |
| 16 - | Selector rod |
| 17 - | Push rod |
| q | With bolt and washer |
| 18 - | Nut |
| q | 20 Nm |
| q | Always renew |
| 19 - | Bolt |
| q | 4 Nm |
| 20 - | Gearbox selector lever |
| q | Install so that gap in splines aligns with selector shaft |
| q | Apply grease if necessary; for grease refer to → Electronic parts catalogue |
| 21 - | Sealing collar |
| 22 - | Ball socket |
| q | Apply grease; for grease refer to → Electronic parts catalogue |
| 23 - | Bearing bush |
| q | To remove pull off retaining clip → Item. |
| 24 - | Connecting rod |
| q | To remove pull off retaining clip → Item. |
| 25 - | Bolt |
| q | 20 Nm |
| 26 - | Retaining clip |
| 27 - | Bolt |
| q | 20 Nm |
