Audi Workshop Service and Repair Manuals

Removing and installing flange shaft (right-side)   Note The flange shaft (right-side) can also be removed and installed with the gearbox in the vehicle → 6-speed manual gearbox 0B1, front-wheel drive; Rep. gr.39. Special tools and workshop equipment required

t  Drift -VW 295-

t  Puller -T10037- t  Sealing grease -G 052 128 A1-

Removing l  Gearbox removed l  Gearbox is secured to gearbox support -T40173- with tensioning strap -1-. –  Tilt gearbox to rear with gearbox support -T40173- to prevent gear oil from escaping.

–  Remove flange shaft (right-side); to do so, secure puller -T10037- to gearbox housing -arrow-.

Installing Installation is carried out in reverse sequence; note the following: –  Always renew circlip for flange shaft -A-. –  Clamp flange shaft in vice, using jaw protectors. Use new circlip -A- to press old circlip out of groove in flange shaft.

–  Check flange shaft oil seal (right-side) -arrow- for damage and renew if necessary → Chapter. –  Pack space between sealing lip and dust lip half-full with sealing grease -G 052 128 A1-. –  Knock flange shaft in with drift -VW 295-.

–  After installing gearbox, unscrew oil filler plug -arrow-, fill up gear oil in gearbox and check oil level → 6-speed manual gearbox 0B1, front-wheel drive; Rep. gr.34.