audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Cooling system/coolant > < Checking oil pressure

A5

Removing and installing radiator outlet coolant temperature senderG83
Removing and installing radiator outlet coolant temperature sender -G83-
Removing
l  Engine cold.
–  Remove front noise insulation → Rep. gr.66.
–  Open filler cap on coolant expansion tank briefly and allow residual pressure in cooling system to dissipate.
   
–  Unplug electrical connector -1- at radiator outlet coolant temperature sender -G83-.
–  Lift retaining clip -2- and pull out radiator outlet coolant temperature sender -G83--3-.
  Note
t  Place a cloth underneath to catch escaping coolant.
t  Insert new radiator outlet coolant temperature sender -G83- immediately into connection to avoid loss of coolant.
Installing
Installation is carried out in the reverse order; note the following:
  Note
Fit new O-rings.
–  Check coolant level → Anchor.
–  Install front noise insulation → Rep. gr.66.
  A19-11457

Cooling system/coolant > < Checking oil pressure