audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing radiator outlet coolant temperature senderG83 > < Coolant pipes, coolant temperature senders, coolant circulation pump - exploded view

A5

Removing and installing coolant temperature senderG62
Removing and installing coolant temperature sender -G62-
   
Removing
l  Engine cold.
–  Remove engine cover panel -arrows-.
  A10-11353
–  To relieve residual pressure in cooling system, open filler cap on coolant expansion tank briefly and then close cap again (it should click into place).
  A19-10535
–  Unplug electrical connector -2-.
–  Pull off retaining clip -1- and pull out coolant temperature sender -G62-.
Installing
Installation is carried out in the reverse order; note the following:
  Note
t  Fit new O-ring.
t  Insert new coolant temperature sender -G62- immediately into connection to avoid loss of coolant.
–  Install body brace → Rep. gr.40.
–  Check coolant level → Anchor.
  A19-10722

Removing and installing radiator outlet coolant temperature senderG83 > < Coolant pipes, coolant temperature senders, coolant circulation pump - exploded view