audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing coolant pipe (top left) > < Removing and installing coolant temperature senderG62

A5

Removing and installing radiator outlet coolant temperature senderG83
Removing and installing radiator outlet coolant temperature sender -G83-
   
Removing
l  Engine cold.
–  To relieve residual pressure in cooling system, open filler cap on coolant expansion tank briefly and then close cap again (it should click into place).
  A19-10535
–  Remove engine cover panel -arrows-.
  A10-11353
–  Unplug electrical connector -2-.
  Note
Place a cloth underneath to catch escaping coolant.
–  Unscrew radiator outlet coolant temperature sender -G83--item 1-.
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torque → Chapter „Coolant pipes, coolant temperature senders, coolant circulation pump - exploded view“
  Note
t  Fit new O-rings.
t  Insert new radiator outlet coolant temperature sender -G83- immediately into threaded hole to avoid loss of coolant.
–  Check coolant level → Anchor.
  A19-11218

Removing and installing coolant pipe (top left) > < Removing and installing coolant temperature senderG62