Audi Workshop Service and Repair Manuals

Removing and installing exhaust manifold (right-side)

Removing –  Remove noise insulation panels -1- and -2- → Rep. Gr.66.

–  Remove Lambda probe -G39--item 1- → Rep. Gr.24. –  Remove plenum chamber partition panel → Rep. Gr.50. –  Remove front silencer (right-side) → Chapter.

–  Remove nuts -arrows- and bolt -1- and move catalytic converter to rear.   Note For illustration purposes, the installation position is shown with the engine removed. –  Remove front right wheel. –  Remove front wheel housing liner (right-side) → Rep. Gr.66.

–  Remove nut -1- and bolt -2- and push coolant pipe clear to one side.   Note Disregard -arrows-.

–  Remove bolts -1 … 4- and detach heat shield.

–  Remove nuts -7- and -9- and detach bracket for heat shield. –  Remove nuts -1 … 6- and -8- and detach exhaust manifold. Installing Installation is carried out in the reverse order; note the following:   Note Renew gaskets and self-locking nuts.

–  Fit exhaust manifold with gasket for catalytic converter and tighten nuts → Fig.. –  Install catalytic converter (right-side): vehicles with manual gearbox/multitronic gearbox 0AW → Chapter, vehicles with automatic gearbox 0B6 → Chapter –  Install plenum chamber partition panel → Rep. Gr.50. –  Install Lambda probe -G39- → Rep. Gr.24 –  Install noise insulation panels → Rep. Gr.66. –  Fit front wheel → Rep. Gr.44.