A6 Quattro Wagon V6-2.8L (AFC) (1995)
Brake Rotor/Disc: Service and Repair
Front Brakes, Servicing
Front brakes, servicing
CAUTION: Always install all parts included in repair kit.
Brakes can be tested on any commercially available brake dynamometer provided the drive roller speed does not exceed 5.5 km/h
(3.3 mph).
1. Guide pin 25 Nm (18 ft lb)
Bolt together with brake pad carrier
2. Cap
Remove for access to guide pin
Lower cap with guide for brake pad wear indicator wiring
3. Brake hose
Do not disconnect to replace brake pads
4. Bracket
Bolt to brake caliper housing
Install harness connector for brake pad wear indicator
5. Bolt 25 Nm (18 ft lb)
6. Harness connector
Disconnect when changing brake pads
7. Brake line
15 Nm (11 ft lb)
Install in brake caliper housing
Connect to brake hose; hold hex on brake hose fitting when tightening
8. Serrated bolt
125 Nm (92 ft lb)
Clean serrations under head when reusing
9. Brake pads
Brake pad wear indicator light, if so equipped, lights up in instrument cluster when brake pads are worn