A8 Quattro Sedan V8-4.2L (AUX) (2001)
CAUTION!
Do not lay the removed valve body on the sensor for transmission RPM (on the back side of the valve body). Otherwise, there is risk of
damage.
Installing
^
Coat O-rings on wiring harness connector with thin layer of Vaseline.
^
Install wiring harness connector in transmission housing.
-
Installation position of wiring harness connector: tabs on collar are horizontal and flattened side of connector must be parallel to oil pan
sealing surface.
-
Fastening and routing of wiring harness on valve body must comply with specifications go to removing and installing wiring harness .
^
Install valve body without force and, while doing so, locate pin of latch washer -1- in groove of selector slide -2-.
^
Install circlip (arrow) for wiring harness connector.