A8 Quattro Sedan V8-4.2L (BVJ) (2008)
![background image](/audi/a8_quattro_sedan/v8-4.2l_(bvj)/Page-542001.png)
Alignment: Procedures
Rear Camber, Adjusting
Rear Camber, Adjusting
-
Remove the wheel bearing housing/track control arm connection nut - A -.
-
Adjust the camber by turning the eccentric bolt - B -.
Specified values for wheel alignment. Refer to => [ Wheel Alignment Specifications ] See: Specifications.
‹› The maximum adjustment range is 90 degrees to the left or right of the center position.
‹› For a better illustration, camber adjustment is shown with wheel removed.
-
Install a new nut - A - and tighten. refer to - item 17 - in => [ Stabilizer Bar, Track Control Arm, Tie Rod, Coupling Rod, Connecting Link,
Trailing Arm and Level Control System Sensor Assembly Overview ] See: Steering and Suspension/Suspension/Stabilizer Bar/Service and
Repair/Rear Suspension/Stabilizer Bar, Track Control Arm, Tie Rod, Coupling Rod, Connecting Link, Trailing Arm and Level Control System
Sensor Assembl.
-
After tightening the nut - A -, check the camber value once more. Refer to => [ Wheel Alignment Specifications ] See: Specifications.