A8L V8-4.2L (BFM) (2004)
Trim Panel: Service and Repair
Upper B-Pillar Trim, Removing and Installing
Upper B-pillar Trim, Removing And Installing
CAUTION: Observe safety precautions for working on side curtain airbags.
1
-
Retainers
-
Qty. 2
2
-
Upper B-pillar trim
Removing
-
Unclip lower B-pillar trim in area of upper B-pillar trim.
-
Remove nuts - 6 - (2x).
-
Remove upper B-pillar trim - 2 - downward.
-
Complete removal: Remove outer anchorage point and thread out belt - 7 -.
Installing
CAUTION: Always adhere to installation sequence for upper B-pillar trim.
-
Complete removal: Install outer floor panel anchorage point and thread in belt - 7 -.
-
Engage upper B-pillar trim - 2 - at brackets - 1 - (2x).
-
Make sure retainer - 4 - engages in mount - 5 - at belt height adjuster.
-
Press on upper B-pillar trim - 2 -.
-
Install nuts - 6 - (2x).
CAUTION: Make sure that trim is firmly seated.
-
Make sure rubber door seal is properly fitted over upper B-pillar trim.
-
Check operation of belt height adjuster.
3
-
Clips
-
Qty. 2
4
-
Retainer at upper B-pillar trim
5
-
Mount at belt height adjuster