A8L V8-4.2L (BFM) (2004)
![background image](/audi/a8l/v8-4.2l_(bfm)/Page-8021005.png)
-
Go to vehicle self diagnosis and check all control modules for DTCs by selecting Gateway installation list -arrow-
-
If any permanent DTCs are stored, follow guided fault finding (GFF) and resolve these concerns before proceeding
(Not part of campaign reimbursement)
-
Disconnect VAS 5051/5052 from vehicle
NOTE:
-
To exit or enter vehicle during the update, manually close driver's door latch first
-
DO NOT OPERATE doors or trunk lid during the MMI update
-
Switch all electrical consumers to "OFF" position (lights, telephone, wipers, climate control, etc.)
-
Switch ignition "OFF" and remove key from ignition lock
-
Proceed to Section C
Section C - MMI Software Update
-
Press and hold ON/OFF knob -arrow A- to turn MMI "ON"
-
Press center control knob -arrow B- to proceed past disclaimer screen
-
Press load button on glove box CD Changer and insert MMI update CD (W42A8317) into first slot (label side up) and wait at least 10 seconds for
system to recognize the CD
-
If necessary, press RADIO button -arrow C- to activate the radio
-
Press and hold SETUP and RETURN buttons (arrows D1 & D2) until MMI screen changes to "Current Config."
NOTE:
SETUP button should be pushed slightly before RETURN button