A8L V8-4.2L (BFM) (2004)
/Page-5247004.png)
^
Tighten nut -3- hand-tight only.
Note: It is not possible to tighten the bolt -A in the control position, therefore this is done with the vehicle standing on the ground in "Normal
level" mode.
^
Install and tighten wheel.
^
Tightening the bolt-4- with the vehicle standing on the ground at normal level. Counterhold nut -3-.
^
Perform the control position adaptation procedure.
See: Suspension/Suspension Control ( Automatic - Electronic )/Testing and Inspection/Programming and Relearning
