A8L Quattro Sedan W12-6.0L (BSB) (2005)
-
Release mounting strips in left and right side panels => [ Rear Bumper Cover Mounting Strip ] See: Rear Bumper Cover Mounting Strip and pull
off cover from vehicle slightly toward rear.
-
The right mounting strip is released by rotating clockwise, left side by rotating counterclockwise.
-
Disconnect all harness connectors to the electrical components and remove cover.
CAUTION!
When installing, a tightening torque of 1 Nm must be observed.
Otherwise, worm gear of mounting strip will be damaged and it will be significantly more difficult to remove the bumper.
Grommets for cover
-
Before installing cover, check that both round grommets - 1 - and oblong grommets - 2 - are pressed into side panel as shown.