A8L Quattro Sedan W12-6.0L (BSB) (2005)
/Page-2412003.png)
-
Set adjustment on heat gun as shown in illustration, with temperature potentiometer - 2 - set to maximum heat and two-stage air flow switch - 3 -
set to level 3.
-
Heat threads of connector-side shear bolts as shown in illustration for approx. 25 to 30 seconds.
CAUTION!
By heating the threads, the retaining tabs, shear bolts and parts of the metal housing become very hot. Do not burn yourself on these
parts! Make sure that only the threads are heated as much as possible, and not any of the surrounding parts. If necessary, cover these
parts.
-
Remove shear bolts with locking pliers (see direction of arrow).
