A8L Quattro Sedan W12-6.0L (BSB) (2005)
-
Install crank - 2 - with drive rod - 1 - loosely in position on wiper shaft.
-
Align crank with wiper frame.
-
Crank must be positioned between marks - arrows - .
-
Hold crank in position with open-ended wrench and tighten nut - 3 - .
-
Switch on ignition.
-
Actuate flick wipe function and allow wiper motor to move to end position.
-
Check whether crank is positioned between marks and re-align if necessary.
-
Switch off ignition and remove ignition key.
-
Install wiper motor with wiper frame in vehicle.
-
Install dome brace. As well as following bolts:
1. Combi bolts, 45 Nm
2. Combi bolts, 3 Nm
NOTE: Disregard - item 3 - , - item 4 - and - arrow - .
-
As well as following bolts:
1. Combi bolts, 9 Nm