A8L Quattro Sedan W12-6.0L (BSB) (2005)
Drive/Propeller Shaft: Removal and Replacement
Driveshaft
Driveshaft
Special tools, testers and auxiliary items required
‹› Alignment Fixture-4W Dr.Shaft (3139)
‹› Counterhold Tool (T10172) with Adapters (T10172/5)
‹› Engine/Transmission Jack (V.A.G 1383 A) with Universal Support (V.A.G 1359/2)
Driveshaft, Removing
‹› See notes, refer to => [ Drive Shaft Assembly Overview ] See: Drive Shaft Assembly Overview.
‹› A twin pillar vehicle hoist should be used when working on the driveshaft.
-
Separate the exhaust system at the clamping sleeves - 1 - and - 2 -.
-
Remove both tunnel braces - A - and - B -.
-
Remove the rear section of exhaust system - C -.
-
Remove the heat shield - arrows -.