A8L Quattro Sedan W12-6.0L (BSB) (2005)
-
Push the driveshaft all the way to the back and mark the position of the center bearing on the body - arrow B -.
-
Push the driveshaft all the way to the right and mark the position of the center bearing on the body - arrow B -.
-
Push the driveshaft all the way to the left and mark the position of the center bearing on the body - arrow B -.
-
Align the driveshaft - arrow C - and - arrow 3 -.
‹› The center bearing must in the center between the markings - arrow A - and - arrow B - or - arrow 1 - and - arrow 2 -.
-
Tighten the center bearing screws to the tightening specification - 8 - => [ Hexagon Bolt ] See: Drive Shaft Assembly Overview.
Continuation
-
Install the heat shield over the center bearing - arrows -.
-
Reconnect exhaust system and ensure it is not under stress.
-
Install both tunnel braces - A - and - B -.