A8L Quattro Sedan W12-6.0L (BSB) (2005)
Drive/Propeller Shaft: Removal and Replacement
Seal For Flange/Driveshaft, Rear Final Drive Installed, Replacing
Seal for Flange/Driveshaft, Rear Final Drive Installed, Replacing
Special tools, testers and auxiliary items required
‹› Engine/Transmission Jack (V.A.G 1383 A) with Universal Transmission Support (V.A.G 1359/2)
‹› Puller (VW 391)
‹› Adapter (VW 771/40) from the Slide Hammer - Complete Set (VW 771)
‹› Retainer (3028)
‹› Pulling Hook (T20143)
‹› Thrust Piece (T40109)
‹› Sealing grease (G 052 128 A1)
‹› 2 hex bolts M 8 x 30
‹› 1 bolt M 8 x 45
Removing
‹› Rear final drive installed
Refer to general repair instructions. Refer to => [ General Repair Information ] See: Rear Final Drive/Service and Repair/Procedures/Rear Final Drive
0AR (02XA,0A3A,09EA,09LA Transmission).
-
Remove the rear section of the exhaust system started at the clamping sleeves - arrows -.
-
Disconnect driveshaft from rear final drive and tie up. Refer to => [ Drive Shaft, Removing from Rear Final Drive and Installing ] See: Rear Final
Drive/Service and Repair/Removal and Replacement/Rear Final Drive 0AR/Removal and Installation/Drive Shaft, Removing From Rear Final
Drive and Installing.
-
Place (V.A.G 1383 A) with (V.A.G 1359/2) under rear final drive.