Cabriolet V6-2.8L (AFC) (1995)
^
Disconnect fuel pressure and return lines from fuel rail
^
Screw (2) plastic covers from new fuel line onto old fuel line
-
Remove 4 screws (arrows) then lift engine cover brackets and fuel rail together with fuel injectors from intake manifold
-
Audi 100/A6, use kit 078 133 651 J
Note:
Use new, clean engine oil as lubricant on lower injector O-rings prior to installation
-
Audi 90 and Cabriolet, use kit 078 133 651 H
Note:
Use new, clean engine oil as lubricant on lower injector O-rings prior to installation
^
Install new fuel rail/injector assembly on intake manifold and push down on each injector until it snaps into position and is properly seated
^
Check for correct position and seating of the clips securing the injector to the fuel line