Cabriolet V6-2.8L (AFC) (1995)
-
Align new guide bearing in rear axle so that:
-
Axes (B and C in illustration) are parallel to each other
-
Bearing is oriented toward direction of travel (arrow at C in illustration)
-
Press guide bearing into rear axle with assembly device.
-
Press in bearing until pin (a in illustration) makes contact with metal bearing housing (arrow in illustration).
-
Lightly coat entire surface of projecting rubber parts of guide bearing with silicone grease, Part No. G 000 405 A2.
-
Carefully raise rear axle using VAG1383A transmission jack and loosely install both mounting bolts in bearing mounts.
-
"a" in illustration = Wooden support
-
Install brake proportioning valve on bearing mount.
-
Connect brake hoses to bracket on both sides.
-
Install regulator spring for brake proportioning valve in lever and fasten loosely with hex bolt.
-
Remove brake pedal support.
-
Bleed brakes.