Q5 Quattro V6-3.2L (CALB) (2009)
‹› Removing and Installing, refer to => [ Door Lock ] See: Rear Door Lock
8
Mounting Bracket
‹› Rear backing - 5 - slid into outer door panel.
‹› To install, engage mounting bracket with loosely installed screw - 10 - in door, slide forward and tighten screw to 2.5 Nm.
9
Actuating Link
‹› Engage in door lock
10
Housing
‹› Before installing, attach cover cap - 7 -.
‹› Removing, refer to=> [ Door Handle ] See: Rear Door Handle/Rear Door Exterior Handle/Service and Repair/Rear Door Handle
11
Cover
‹› Removing and Installing, refer to => [ Remove the Housing Cap ] See: Service and Repair/Rear Housing
12
Magnet
‹› For vehicles with the keyless entry system
13
Door Handle Trim
‹› For vehicles without the keyless entry system
‹› Removing and Installing, refer to => [ Handle Trim ] See: Front Door/Service and Repair/Front Doors
14
Rear Outside Door Handle Touch Sensor
‹› For vehicles with the keyless entry system
‹› Removing and Installing, refer to => [ Rear Outside Door Handle Touch Sensor ] See: Rear Door Handle/Rear Door Exterior Handle/Service
and Repair/Rear Outside Door Handle Touch Sensor