Q5 Quattro V6-3.2L (CALB) (2009)
Rear Door Striker: Service and Repair
Rear Door Striker Pin
Striker Pin
Removing
-
Remove the bolts- 2 - and the striker pin - 1 -.
Installation
To install, perform the steps used in removal in reverse order.
‹› The striker pin backing must be position with the pins - arrows - exactly in the hole.
‹› The striker pins must be sheared off cleanly after sliding the striker pin.
‹› If a new part is being installed, then remove the sheared off pins from the striker pin.
-
Adjusting striker pin, refer to => [ 3. Adjusting with Striker Pin ] See: Adjustments