Q5 Quattro V6-3.2L (CALB) (2009)
Sunroof / Moonroof Weatherstrip: Service and Repair
Inner Seal
Inner Seal
-
Remove the front glass panel. Refer to => [ Glass Panel ] See: Sunroof / Moonroof Panel/Service and Repair/Glass Panel.
-
Remove the rear glass panel. Refer to => [ Rear Glass Panel ] See: Sunroof / Moonroof Panel/Service and Repair/Rear Glass Panel.
-
Remove the inner seal - 2 - from the frame - 1 -.
-
Remove any remaining adhesive with adhesive remover (VAS 6349).
-
Adhesion surface must be free of dust and grease.
-
Clean the surfaces thoroughly with cleaning solution (D 009 401 04).
-
Wipe down the surfaces on the frame with the supplied primer towel.
-
Position the inner seal - 2 - onto the frame surfaces- 1 - with the joint in the center of the rear roof cut-out.
-
Peel off the protective film from the adhesive strip - 3 - on the new inner seal in sections and press the seal on.
-
Press the inner seal on evenly to prevent any excess length.
-
Using the roller (3356) press the inner seal two times firmly and evenly all the way around.
-
Install the rear glass panel. Refer to => [ Rear Glass Panel ] See: Sunroof / Moonroof Panel/Service and Repair/Rear Glass Panel.
-
Install the front glass panel. Refer to => [ Glass Panel ] See: Sunroof / Moonroof Panel/Service and Repair/Glass Panel.