Q5 Quattro V6-3.2L (CALB) (2009)
/Page-1486004.png)
Position the motor bolts by hand and screw in a few turns. If threads are damaged, entire brake caliper must be replaced!
-
Tighten motor bolts. Tightening specification: 12 Nm
-
Connect the connector to the motor.
‹› Only insert connector by hand to avoid damaging it.
‹› Make sure that connectors on vehicle side and actuator side are free of dirt and damage.
-
Install motor in the bracket.
-
Install wheels => Wheel and Tire Guide 44 General Information.
After replacing actuator, basic setting 006 must be performed with the vehicle diagnostic tester in the EPB function.
-
Connect the vehicle diagnosis, testing and information system (VAS 5051B) or (VAS 5052) to the 16-pin Data Link Connector (DLC) in the
vehicle with the ignition switched off.
