Q5 Quattro V6-3.2L (CALB) (2009)
/Page-745004.png)
Risk of damage when installing valve stem seals.
‹› Place plastic sleeve - A - that is attached to valve stem seals - B - on valve stem.
-
Lightly oil valve stem seal.
-
Slide valve shaft seal onto plastic sleeve.
-
Carefully press valve stem seal onto valve guide with Valve Stem Seal Drive (3365).
-
Remove plastic sleeve again.
When the valve keepers were removed from the installation cartridge, they must be inserted in the valve keeper inserting tool ( VAS 5161/18) next.
‹› The large diameter of the valve keepers point upward.
-
Press installation cartridge from above onto valve keeper inserting tool and capture keepers.
-
Insert valve spring and valve spring plate => [ Installed position of valve spring ] See: Camshaft, Lifters and Push Rods/Service and
Repair/Valvetrain Assembly Overview
