Q5 Quattro V6-3.2L (CALB) (2009)
/Page-769004.png)
-
Clean sealing surfaces; they must be free of oil and grease.
-
Clean threaded holes in the cylinder block for connecting the engine and transmission using a thread tap before installing the transmission.
-
Clean old sealant out of the holes - arrow - in the cylinder head seals.
‹› With cylinder head installed, holes in cylinder head seal are only half visible.
CAUTION!
The cylinder head seal could be damaged.
‹› Only bend ends of cylinder head seals slightly, do not kink.
‹› A kinked cylinder head seal must be replaced.
-
Bend the end of the cylinder head seals down slightly - arrows - until the upper sealing surface of the seals and the cylinder head can be cleaned.
