audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Air Routing in Air Intake Housing and A/C Unit Overview|Page 8993 > < Air Routing in Air Intake Housing and A/C Unit Overview|Page 8991
Page 3
background image

‹› The right temperature door motor (V159) is  installed only on vehicles equipped with the "Comfort" A/C system. 

-

Remove the screw - B -.

-

Remove the screw - C -.

‹› The bolt - C - , on vehicles equipped with the " Comfort" A/C system, was already moved when the right footwell  door motor (V109) and the

right center vent motor   (V111) were removed.

-

Remove screws - D -.

-

Disconnect the right radiator housing - E - (together  with the right temperature door motor (V159))  from the A/C unit; when doing this, pay
attention to the lever on the door  for the dash panel vents - F - ("right center" on  vehicles equipped with the "Comfort" A/C system, or "center "
on vehicles equipped with the "Basis" A/C system).

Installing

Installation is carried out in the reverse order, when doing this  note the following.

-

Check the heat exchanger - A - and evaporator -  B - for dirt; clean if necessary.

Air Routing in Air Intake Housing and A/C Unit Overview|Page 8993 > < Air Routing in Air Intake Housing and A/C Unit Overview|Page 8991