Q5 Quattro V6-3.2L (CALB) (2009)
-
Press the connector release catch - D - - arrow - and remove the connectors - A - and - B -.
Installing
Installation is carried out in the reverse order, when doing this note the following.
‹› When replacing the A/C control head climatronic control module (J255) be sure to pay attention to precise assignment, refer to => [ Climatronic
Control Module Allocation ] See: Description and Operation.
Installing the Trim to the A/C Control Head
-
Clean the adhesive surface - D - on the A/C control head - A - for example with cleaning solution (D 009 401 04).
-
Install the A/C control head - A -.
‹› The trim piece - B - is supplied with a two sided adhesive strip already installed - C -.
‹› If the trim piece - B - is going to be reused when replacing the climatronic control module (J255) - A -, A/C control head, then remove the
adhesive strip - C - from the trim - B -. Clean the adhesive surface on the trim - B - as described in the instructions which came with the adhesive
strip. Affix to the trim piece - B - a strip (dimension: 204 mm x 10 mm) of the two sided adhesive strip - C - with material strength approximately
1.2 mm (for example with adhesive tape D 438 515 A1.
-
Mount the trim piece - B - with the adhesive tape - C - onto the adhesive surface - D - on the A/C control head - A - and the align it - B -.
-
Press the trim piece - B - onto the surface - D -.
‹› After replacing/installing the A/C control head climatronic control module (J255), always perform the follow work. Refer to => Vehicle
Diagnosis, Testing and Information System VAS 5051 in "Guided Fault Finding" function.