Q5 Quattro V6-3.2L (CALB) (2009)
-
Remove coolant pipes from the coolant hoses by loosening the hose clamps - 1 - and - 2 -.
‹› The installation location is shown with the power steering pump removed.
Installing
‹› Tightening specifications. Refer to => [ Coolant Pipes Assembly Overview ] See: Coolant Pipes Assembly Overview.
Installation is performed in reverse order of removal, noting the following:
‹› Replace O-ring.
‹› Secure all hose connections with hose clamps appropriate for the model.
-
Clean and smooth O-ring sealing surface.
-
Coat O-ring with coolant and slide it onto the coolant pipe.
-
Install A/C compressor bracket. Refer to => [ Ribbed Belt Drive Assembly Overview ] See: Drive Belt/Service and Repair/Ribbed Belt Drive
Assembly Overview.
-
Install A/C compressor. See: Heating and Air Conditioning/Compressor HVAC
-
Install After-Run Coolant Pump (V51). Refer to => [ After-Run Coolant Pump ] See: Engine, Cooling and Exhaust/Cooling System/After-Run
Coolant Pump/Service and Repair/After-Run Coolant Pump.
-
Fill with coolant => [ Filling ] See: Engine, Cooling and Exhaust/Cooling System/Service and Repair/Procedures.