Q5 Quattro V6-3.2L (CALB) (2009)
/Page-1126001.png)
Fuel Gauge Sender: Service and Repair
Fuel Level Sensor
Fuel Level Sensor
Removing
-
Observe safety precautions. Refer to => [ Safety Precautions ] See: Emission Control Systems/Evaporative Emissions System/Service Precautions.
-
Observe rules for cleanliness. Refer to => [ Clean Working Conditions ] See: Service and Repair/Clean Working Conditions.
-
Remove fuel delivery unit. Refer to => [ Fuel Delivery Unit ] See: Fuel Pump/Service and Repair/Fuel Delivery Unit.
-
Release retaining tabs - arrows - with a screwdriver and pull the Fuel Level Sensor (G) upward and out.
CAUTION!
Risk of damage.
‹› Before disconnecting electrical connectors on Fuel Level Sensor (G), first release connector contact retaining tab.
-
Disengage electrical connectors - 1 to 3 - and disconnect them.
Installing
Installation is in reverse order of removal, note the following:
-
Connect electrical connections - 1 through 3 - and make sure they are securely engaged.
