Audi Workshop Service and Repair Manuals

‹› 90 Nm plus an additional 90° turn

‹› Always replace after removal

‹› Must be tightened in the curb weight position, refer to => [ Wheel Bearing, with Coil Spring, Lifting to Curb Weight Position ] See: Service

and Repair/Rear Suspension/Wheel Bearing, with Coil Spring, Lifting to Curb Weight Position

22

Bolt

‹› 120 Nm plus an additional 360° turn

‹› Always replace after removal

‹› Must be tightened in the curb weight position, refer to => [ Wheel Bearing, with Coil Spring, Lifting to Curb Weight Position ] See: Service

and Repair/Rear Suspension/Wheel Bearing, with Coil Spring, Lifting to Curb Weight Position

‹› Axle alignment is necessary if the bolt is removed.

23

Spacer tube

‹› Always replace after removal

24

Nut

‹› Always replace after removal

CAUTION!
‹› Do not tighten the threaded connection using the nut.

‹› Axle alignment is necessary if the nut is loosened.

25

Lower transverse link

26

Bonded rubber bushing

‹› Replace, refer to => [ Wheel Bearing Housing Bonded Rubber Bushing ] See: Wheel Bearing Housing Bonded Rubber Bushing

27

Wheel bearing housing

‹› Removing and installing, refer to => [ Wheel Bearing Housing ] See: Wheel Bearing Housing

28

Bolt

‹› 80 Nm plus an additional 90° turn

‹› Always replace after removal

29

Washer

‹› Serves as corrosion protection

‹› Always use

30

Bolt

‹› 150 Nm plus an additional 180° turn

‹› Always replace after removal

‹› Must be tightened in the curb weight position, refer to => [ Wheel Bearing, with Coil Spring, Lifting to Curb Weight Position ] See: Service

and Repair/Rear Suspension/Wheel Bearing, with Coil Spring, Lifting to Curb Weight Position

31

Shock Absorbers

‹› Removing and installing, refer to => [ Shock Absorber ] See: Suspension Strut / Shock Absorber/Service and Repair/Removal and