Q5 Quattro V6-3.2L (CALB) (2009)
Acceleration Sensor: Service and Repair
Rear Body Acceleration Sensor
Rear Body Acceleration Sensor
Special tools, testers and auxiliary items required
‹› Torque Wrench (V.A.G 1410)
Removing
-
Remove left rear wheel.
-
Remove left rear wheel housing liner. Refer to =>
Body Exterior 66 Removal and Installation.
-
Release and remove the connector - 2 -.
-
Remove bolts - 1 - and sensor - 3 -.
Installing
Installation is in reverse order of removal. Observe the following when doing so:
When installing, always pay attention to the installation position of the sensor.
-
Install sensor - 3 - as illustrated.