Q5 Quattro V6-3.2L (CALB) (2009)
-
Remove bolts - 1 - through - 8 - and remove the subframe.
Installing
Installation is in the reverse order of removal. Observe the following when doing so:
Tightening specifications. Refer to: => [ Subframe, Crossbrace, Stabilizer Bar, Coupling Rod and Subframe Shield Assembly Overview ] See:
Stabilizer Bar/Service and Repair/Front Suspension/Subframe, Crossbrace, Stabilizer Bar, Coupling Rod and Subframe Shield Assembly Overview
Tightening specifications. Refer to: => [ Mounting Bracket, Shock Absorber Fork, Upper Control Arm and Tower Brace Assembly Overview ] See:
Suspension Control ( Automatic - Electronic )/Air Spring/Service and Repair/Mounting Bracket, Shock Absorber Fork, Upper Control Arm and
Tower Brace Assembly Overview
Tightening specifications. Refer to: => [ Track Control Arm, Ball Joint, Guide Link and Level Control System Sensor Assembly Overview ] See:
Sensors and Switches - Suspension/Suspension Control Pressure Sensor/Switch/Service and Repair/Front Suspension/Track Control Arm, Ball Joint,
Guide Link and Level Control System Sensor Assembly Overview
Tightening specifications. Refer to: => [ Wheel Bearing Housing and Wheel Bearing Unit Assembly Overview ] See: Rear Knuckle/Service and
Repair/Front Suspension
Subframe bolting procedure: