Q5 Quattro V6-3.2L (CALB) (2009)
25
Nut
‹› 95 Nm
‹› Always replace after removal
‹› Must be tightened in the curb weight position, refer to => [ Wheel Bearing, with Coil Spring, Lifting to Curb Weight Position ] See: Service
and Repair/Rear Suspension/Wheel Bearing, with Coil Spring, Lifting to Curb Weight Position
26
Eccentric washer
27
Tie Rod
‹› Note the installation position
28
Eccentric bolt
29
Front bonded rubber bushing
‹› For subframe mounting
‹› Two different versions were installed during production, a conventional bonded rubber bushing and a hydraulic bonded rubber bushing
‹› Oil on the hydraulic bonded rubber bushing is a sign of wear.
‹› Replace, refer to => [ Subframe Bonded Rubber Bushing and Hydraulic Bonded Rubber Bushing ] See: Rear Subframe Mount/Service and
Repair
30
Bolt
31
Clip
‹› Not installed on all vehicles.
32
Left stone deflector
‹› Not installed on all vehicles.
33
Rear Final Drive
34
Differential crossmember
35
Bolt
36
Center stone deflector
‹› Not installed on all vehicles.
37
Right stone deflector
‹› Not installed on all vehicles.
38
Bolt
‹› 9 Nm
39
Bolt
‹› 5 Nm
Bonded rubber bushing