Q5 Quattro V6-3.2L (CALB) (2009)
-
Install drive axle. Refer to => [ Drive Axle ] See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and
Repair/Removal and Replacement/Front Suspension/Drive Axle.
-
Tighten wheel. Refer to => Wheel and Tire Guide 44 Specifications.
-
On vehicles with automatic headlamp range control system, perform basic setting of headlamps.
-
If the Vehicle Level Sensor was removed and installed on a vehicle with electronic damper regulation or if the linkage was loosened, the control
position must be reprogrammed. Refer to => [ Control Position, Programing using VAS 5051B ] See: Suspension Control ( Automatic - Electronic
)/Testing and Inspection.
-
If the control position was reprogrammed on vehicles with lane assist, the Directional Stabilization Assistance Control Module ( J759) must be
recalibrated. Refer to => [ Lane Assist Calibration Procedure ] See: Alignment/Service and Repair/Procedures/Lane Assist Calibration Procedure.