Q5 Quattro V6-3.2L (CALB) (2009)
/Page-1263003.png)
-
Coat outer edge of shaft seal with axle oil.
‹› Installation position: The open side of the seal faces the housing.
-
Drive in new shaft seal until seated using thrust piece (T40190). When doing this, do not bend the seal.
-
Fill area between sealing lip and dust lip halfway with sealing grease (G 052 128 A1).
-
Install the flange shaft - A - in the center differential housing using the bracket (VW 441) and punch (VW 412). To do this, place the housing on
the pressure plate (VW 401) and pressure plate (VW 402).
