Q5 Quattro V6-3.2L (CALB) (2009)
CAUTION!
There is the risk of an accident.
‹› The Engine/Transmission Jack (V.A.G 1383 A) may only be used during assembly and must not sit unsupervised under the vehicle.
-
Remove tunnel crossmember bolts - arrows -.
-
Remove nuts - arrow - and the tunnel crossmember.
Installing
Install in reverse order, paying attention to the following:
‹› Tightening specifications. Refer to => [ Tunnel Crossmember, Transmission Mount and Transmission Support Assembly Overview ] See: Tunnel
Crossmember, Transmission Mount and Transmission Support Assembly Overview.
-
Install the noise insulation.