Q5 Quattro V6-3.2L (CALB) (2009)
/Page-1357007.png)
In place of the Assembly Tool - 3 - use (T10065/2), (T10065/3) or (T10065/6 ), depending on the version of the axle shaft.
Tripod roller star, pressing onto axle shaft
The chamfer on star faces toward axle shaft, this is used as an assembly aid.
-
Before installing joint or triple roller star, splines - A - must be lightly coated with grease used in joint.
-
Install triple roller star onto shaft as per markings and drive in to stop.
Depending on the version of the axle shaft, use Assembly Tool (T10065/2) (T10065/3) or ( T10065/6) - 2 - and make sure it fits into the axle shaft -
arrow - from underneath.
-
Use special tool shown in illustration.
1. Assembly Tool (T10065/1)
2. Depending on the version of the axle shaft, the Assembly Tool (T10065/2) or (T10065/XX) must fit into the axle shaft on the bead - arrow - from
