Q7 Quattro V6-3.6L (BHK) (2007)
Trunk / Liftgate Interior Trim Panel: Removal and Replacement
Rear Lid Trim, Removing and Installing
Rear Lid Trim, Removing And Installing
Special tools, testers and auxiliary items required
-
Trim removal wedge 3409
-
Pry lever 80-200
Removing
-
Remove upper center trim from rear lid.
-
Remove upper left and right trim from rear lid.
-
Remove left and, if present, right luggage compartment lights - 1 -.
-
If present, unclip Rear Lid Lock Button (in luggage compartment) E406 - 2 -.
-
Disconnect electrical connectors.
-
Unclip inner left and right tail lamp cover with Trim Removal Wedge 3409.
-
Remove bolts - 4 -.
-
Open warning triangle cover - 5 - in - direction of arrow -.
-
Remove warning triangle and remove 2 screws below - 6 -.
-
Remove remaining lower trim screws - 3 - on rear lid.
-
Carefully remove lower trim from rear lid by loosen trim clamps with Pry Lever 80-200.
-
Grasp between trim and rear lid and disengage remaining clamps.
Installing