Q7 Quattro V6-3.6L (BHK) (2007)
Trim Panel: Service and Repair
Luggage Compartment Side Trim, Removing and Installing
Luggage Compartment Side Trim, Removing And Installing
Special tools, testers and auxiliary items required
-
Trim removal wedge 3409
Removing
-
Remove luggage compartment floor.
-
Remove rear shelf - 1 -.
-
Fold second row backrests - 2 - and, if present, 3rd row backrests - 3 - down.
-
Remove rear cross panel trim.
-
If present, remove securing eyes - 4 -.
-
Remove gap cover - 5 -.
-
Remove C-pillar trim - 6 - from body.
NOTE:
-
C-pillar trim can be left hanging on seat belt webbing - 7 -.
-
To remove C-pillar trim, wheel housing trim must be removed from body.
-
In order to remove trim, belt webbing must be guided out from seat belt through trim. That is not necessary when removing trim.
-
Remove screw - arrow - and remove luggage compartment side trim - 8 - from D-pillar.
-
If present, disconnect electrical connectors.
Installing
Installation is reverse of removal. Observe the following when doing so:
NOTE:
-
If trim clamps remain in body mounting points, remove these and insert them in trim.
-
Check clamps for damage or deformation, replace if necessary.
-
After installing luggage compartment side trim, attach C-pillar trim to body.
-
Then attach wheel housing trim to body.