Q7 Quattro V6-3.6L (BHK) (2007)
-
Insert wheel housing trim with mounts - 1 - in luggage compartment side trim - 2 -.
-
Clip wheel housing trim with clamps - 3 - to C-pillar while inserting tab - arrow A - in recess - arrow B - in C-pillar trim.
-
Install rear cross panel trim.
-
Draw seal lip over luggage compartment side trim.
-
Lay luggage compart floor in luggage compartment.
Tightening torques
Component
Nm
Rear cross panel trim on body
35
Securing eyes to body
4
Gap cover to body
4
Side luggage compartment trim on body
3.5