Q7 Quattro V6-3.6L (BHK) (2007)
Trim Panel: Service and Repair
Wheel Housing Trim, Removing and Installing
Wheel Housing Trim, Removing And Installing
Wheel housing trim, releasing from C-pillar and attaching (not removing)
Special tools, testers and auxiliary items required
-
Trim removal wedge 3409
Removing
CAUTION: Observe safety precautions for work on airbags.
Vehicles with fixed second row
-
Remove corresponding second row seat.
-
Seat beach (two-thirds bench)
-
Individual seat
Vehicles with fore and aft adjustable second row
-
Move second row seat forward on side to be removed.
Procedure for all vehicles
-
Pull wheel housing trim out of mounts in body with Trim Removal Wedge 3409.
-
Remove belt anchor/seat belt screw - 1 - on body.
-
Remove wheel housing trim - 2 - and pull seat belt - 3 - through opening - arrow A - in trim.
Installing
Installation is reverse of removal. Observe the following when doing so:
CAUTION: Observe safety precautions for work on airbags.
NOTE:
-
If trim clamps remain in body mounting points, remove these and insert them in trim.
-
Check clamps for damage or deformation, replace if necessary.