Q7 Quattro V6-3.6L (BHK) (2007)
/Page-5573001.png)
Air Door Actuator / Motor: Service and Repair
Retaining Plate With Left Footwell Flap Motor V108 and Left Temperature Flap Motor V158,
Removing and Installing
Retaining Plate With Left Footwell Flap Motor V108 And Left Temperature Flap Motor V158, Removing And Installing
NOTE:
-
Installed only in vehicles with "Comfort" version A/C system
-
On vehicles with a "Basic" version front A/C control head Climatronic Control Module J255, footwell flaps and temperature flaps on left and right
sides are operated by one control motor respectively, it is fastened at right on the heating A/C unit (both left and right flaps are connected to each
other via a shaft, the control motors are fastened at right on heating A/C unit).
Removing
-
Switch ignition on
-
Bring control motors into service position, perform basic setting of A/C system (display group "005") to do this Vehicle Diagnosis, Testing and
Information System VAS5051 in the "Guided Fault Finding" function.
-
As soon as control motors are located in service position, switch ignition off Vehicle Diagnosis, Testing and Information System VAS5051 in the
"Guided Fault Finding" function.
NOTE: Control motors can only be re-installed in the service position after removal.
-
Remove lower left instrument panel trim.
-
Remove accelerator pedal module.
-
Release relay carrier (with control modules) which is installed in left area next to heating A/C unit and set it aside.
-
Remove air channel for air duct in drivers footwell.
-
Remove left cover of heater core.
-
Remove bolts - A -.
NOTE: Bolts - C - are not loosened or removed to remove retaining plate - B -, they are used to guide the retaining plate.
-
Pull out retaining plate - B - with control motors downward.
-
Mark connectors - D - and - E - (risk of interchange) and disconnect them.
Installing
-
Check levers of both control motors - A - and - B -, retaining plate can only be installed correctly when they are located in the position depicted
(service position).
