Q7 Quattro V6-3.6L (BHK) (2007)
Air Door Actuator / Motor: Service and Repair
Left Rear Temperature Flap Motor V313, Removing and Installing
Left Rear Temperature Flap Motor V313, Removing And Installing
NOTE: With Left Rear Temperature Flap Position Sensor G391
Removing
-
Switch ignition off
-
Bring rear heating A/C unit into service position
-
Remove (unhook) lever - 1 - from Left Rear Temperature Flap Motor V313.
-
Remove mounting bolts - 2 -.
-
Disconnect electrical connection from Left Rear Temperature Flap Motor V313 and remove control motor.
Installing
-
Install the removed components again in reverse order.
-
Check DTC memory of front A/C control head Climatronic Control Module J255 and of Rear A/C Control Head (Climatronic) E265 and erase
DTCs displayed if necessary. Vehicle Diagnosis, Testing and Information System VAS 5051 in "Guided Fault Finding" function.
-
Perform basic setting (and output Diagnostic Test Mode (DTM) if necessary) on the A/C system. Vehicle Diagnosis, Testing and Information
System VAS 5051 in "Guided Fault Finding" function.