audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Fresh Air Intake Housing A/C System, Removing and Installing|Page 15153 > < Fresh Air Intake Housing A/C System, Removing and Installing|Page 15151
Page 4
background image

‹› Versions of footwell vents - A - and - B - vary on vehicles with and without rear heating & A/C unit, this illustration shows the version on vehicles

with rear heating & A/C unit => [ Air Ducts in and to Front and Rear Heating and A/C Unit ] See: Description and Operation/Air Ducts in and to
Front and Rear Heating and A/C Unit. 

-

Remove condensation water drain hose from heating & A/C unit => [ Front Water Drain Hose ] See: Evaporator Drain Tube/Service and
Repair/Front Water Drain Hose.

-

Mark the installation position of washers of hex nuts -  C - on plenum chamber rear wall e.g. using a waterproof marker.

-

Remove hex nuts with washer - C -

‹› A rubber base - D - is glued on to washer of hex nuts -  C - as a seal.

-

Check fit of sealing caps - A - and - B - on connections to evaporator, they must fit securely so that the connections are not damaged when
removing the heating and A/C unit.

-

Disconnect harness connector - A -.

Fresh Air Intake Housing A/C System, Removing and Installing|Page 15153 > < Fresh Air Intake Housing A/C System, Removing and Installing|Page 15151