Q7 Quattro V6-3.6L (BHK) (2007)
‹› Assembly sleeve knurl faces away from combustion chamber seal.
-
Position assembly cone (T10133/5) on fuel injector and slide combustion chamber seal with assembly sleeve (T10133/6) farther onto fuel injector.
-
Remove assembly cone (T10133/5) and assembly sleeve (T10133/6) and slide combustion chamber seal into groove by hand.
-
Position spacer sleeve (T10133/11) on valve body.
-
Press sizing sleeve (T10133/7) over combustion chamber as far as stop on spacer sleeve (T10133/11) and remove again.