Q7 Quattro V6-3.6L (BHK) (2007)
‹› With gravity valve and fuel filter housing
‹› Installed location => [ Install new locking flange seal dry. ] See: Fuel Pump/Service and Repair/Fuel Delivery Unit.
‹› Fuel filter, removing and installing => [ Fuel Filter, Assembly Overview ] See: Fuel Filter/Service and Repair/Fuel Filter, Assembly Overview.
16
Fuel line
‹› To fuel pressure regulator at right locking flange
‹› To disconnect, press release button on connection piece
17
Fuel line
‹› From Fuel Pump (FP)
‹› To disconnect, press release button on connection piece
18
Fuel level sensor 2 (G169)
‹› Clipped in at retaining ring - 19 -
‹› Resistance values, checking => [ Fuel Level Sensor 2, Checking ] See: Testing and Inspection/Fuel Level Sensor 2, Checking.
‹› Removing and installing => [ Fuel Level Sensor 2 ] See: Fuel Level Sensor 2.
19
Retaining ring
‹› Welded to fuel tank
‹› For suction jet pump and fuel level sensor 2 (G169)
20
Rear suction jet pump
‹› Removing and installing => [ Suction Jet Pumps ] See: Fuel Pump/Service and Repair/Suction Jet Pumps.
Locking Flange Cover
-
Tighten bolts - 1 through 4 - to 9 Nm.